The Model C48 Timer is available in Single or Dual Preset models.
The Model C48 Timer
is available in Single or Dual Preset models. The C48T features a 7
segment, 2 line by 6 digit reflective or backlit LCD display. For the
backlit versions, the main display line is red and shows the timer
value. The smaller secondary display line is green, and can be used to
view the preset values or output time values.
The C48 timer can
be configured for a variety of different operating modes to meet most
timing application requirements. Twelve timing ranges are available from
thousandths of a second to hours and minutes. Decimal Points are used to
separate the time units (hours, minutes, seconds). Timing can be
cumulative or can reset and start upon each power cycle."On
Delay" or "Off Delay", "Single Shot",
"Repetitive auto cycling" modes are all supported.
Features
LCD, 7
segment, 2 line, 6 digit display, positive reflective or
negative transmissive models with red top line and green
bottom line
Solid
state and relay output models
Field
replaceable relay output boards
Status
indicators for outputs
NEMA
4X/IP65 Sealed Front Bezel
Programmable
user inputs and front panel function key
Horizontal
or vertical stacking of multiple units
85 to
250 VAC or 18 to 36 VDC/24 VAC powered units
RS485
serial communications options
UL
Recognized Component, File # E137808
SPECIFICATIONS
Display
2 Line by 6 digit
LCD display; Positive image reflective or negative image transmissive
with red (top line) and green (bottom line) backlighting.
Main Display
0.3" (7.62 mm)
high digits
Secondary Display
0.2" (5.08 mm)
high digits
Power
Requirements
AC Versions
AC Power: 85 to 250
VAC, 50/60 Hz, 9 VA max
DC Power
11 to 14 VDC @ 150
mA max (Non PNP output models)
Note: Models with
PNP current sourcing outputs must be powered from AC.
DC
Versions Continuous
DC Power
18 to 36 VDC; 5.5 W
max
AC Power
24 VAC ± 10%;
50/60 Hz; 7 VA max
Note: The +10%
tolerance range on AC input voltage must be strictly adhered to. DO NOT
EXCEED 26.4 VAC.
Sensor Power
+12 VDC (± 15%) @
100 mA max.
Inputs
Run/Stop, Usr. In1,
Usr In2, and Usr. In3.
Configurable as
current sinking (active low) or current sourcing (active high) inputs
via a single plug jumper.
현재위치 : 
개
